Signed-off-by: Stefan Weil <sw@weilnetz.de>

The command was introduced in v2022.1 with #2459.

Co-authored-by: Jan-Niklas Burfeind <github@aiyionpri.me>

If the uci option 'gluon.wireless.preserve_channels' is set then the channel width of wireless radios (htmode) is preserved during updates, too.

Signed-off-by: David Bauer <mail@david-bauer.net>

- explain what happens on gluon-reconfigure
- show workflow to alter the wired network config
- update examples
- update 'has changed in' section

resolves #2474

Co-authored-by: Tom Herbers <mail@tomherbers.de>
Co-authored-by: David Bauer <mail@david-bauer.net>
Co-authored-by: Andreas Ziegler <dev@andreas-ziegler.de>

Co-authored-by: Tom Herbers <mail@tomherbers.de>
Co-authored-by: David Bauer <mail@david-bauer.net>
Co-authored-by: Andreas Ziegler <dev@andreas-ziegler.de>

closes freifunk-gluon/gluon#2603

Co-authored-by: Martin Weinelt <martin@darmstadt.freifunk.net>

- Restructure page
- Add information on how to add L2TPv3 offloading support to a build
  using configurable ciphers. The null method is not reocmmended anymore.
- Add notes and pointers regarding the gateway configuration to provide
  gateway admins with hints on how to modify their configuration to
  accommodate this new feature.
- Mention wireguard support

Based-on-patch-by: Felix Kaechele <felix@kaechele.ca>

2 spaces is the most common indentation width used in the docs; adjust
the rest for consistency.

Also change .editorconfig accordingly.

Replace occurences of ar71xx with ath79. Remove references of ar71xx
targets which are not relevant anymore.

Explains the behaviour when DATE is either in the future or in the past
and hints at how the firmware rollout can be controlled using the
PRIORITY variable.

Co-Authored-By: Martin Weinelt <martin@darmstadt.freifunk.net>

Document the behavior of the Outdoor mode when preserve_channels is
enabled.

Document the behavior of the Outdoor mode when preserve_channels is
enabled.

This reverts commit 4e070312.

The recommendation is not sufficient at this time, so revert it.

See #1898 for further discussion.

many AVM devices do not have RESET/WPS buttons. So use the otherwise unused DECT/PHONE button to boot the device into setup mode.

This patch allows to enter the setup-mode by pressing the phone button
(often labeled as DECT) in addition to WPS and reset button.

This patch is necessary to allow supporting boards without a WPS and reset
button (e.g. AVM FRITZ!Box 7312).

This reverts commit b92e4044.

Committing in this case is unnecessary as that job is already handled by 998-commit
which is in a superior position to commit, as it is run after all relevant changes to
the configuration have been made.