At the moment, we don't have a good guideline for package-specific
configuration, but it seems like a good idea not to split configuration
into too many tiny pages, especially for packages that aren't commonly
selected explicitly.

Some uncommon configuration is dropped from the example site.conf to remove
clutter.

We must ensure that each node becomes IGMP/MLD querier for its local
clients; having only a single querier for the whole mesh is generally
unreliable, leading to frequent "IGMP/MLD querier appeared/disappeared"
messages from batman-adv and unreliable snooping.

In smaller meshes it might be interesting only segment querier domains, but
allow membership reports to pass through the mesh, in order to support
snooping switches outside the mesh without special configuration. A
site.conf switch is provided to control this behaviour.

Fixes #1320

[Matthias Schiffer: slightly clean up code]

This package drops all incoming router advertisements except for the
default router with the best metric according to B.A.T.M.A.N. advanced.

Note that advertisements originating from the node itself (for example
via gluon-radvd) are not affected.

This patch adds a new gluon-ebtables package to filter IGMP/MLD messages
via ebtables.

For one thing this reduces multicast overhead: About one third of all
ICMPv6 multicast traffic in Lübeck or Hamburg is MLD.

Furthermore it removes a potential Distributed Denial-of-Service vector
(see Gluon ticket #553).

Finally, it is a prerequisite for enabling bridge multicast snooping in
a decentral and robust fashion.

Note that IGMP/MLD are filtered for multicast traffic coming from
the mesh, too (new MULTICAST_IN), as unfortunately there seem to
be other queriers somewhere in the mesh at least for Freifunk
Lübeck. Also adding these rules to be prepared to anyone intentionally
or unintentionally disabling these filters on his/her node.

Node operators not running Gluon (for instance gateway nodes) should
make sure to either enable multicast_router towards bat0 or disable
multicast snooping entirely if they have a bridge on top of bat0.

Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>

This package provides br-client and sets up a wireless AP interface for
clients.

gluon-radio-config contained only a single file. The code has been adjusted
to allow creating a Gluon configuration without WLAN support by removing
the wifi24 and wifi5 sections from site.conf.

Split basic radio configuration from gluon-mesh-batman-adv as this will
be required for virtually any wireless mesh protocol.

This package takes care of setting:

  - wireless channel,
  - htmode and
  - regulatory domain

gluon-mesh-batman-adv-core depends on this package.