Hardware specification:
- SOC: Qualcomm QCA9563 @ 775MHz
- Flash: GigaDevice GD25Q64CSIG (8MiB)
- RAM: Zentel A3R1GE40JBF (128 MiB DDR2)
- Ethernet: Qualcomm QCA8337N: 4x 1Gbps LAN + 1x 1Gbps WAN
- Wireless:
  - 2.4GHz (bgn) QCA9563 integrated (3x3)
  - 5GHz (ac) Qualcomm QCA9886 (2x2)
- Button: 1x power, 1x reset, 1x wps
- LED: 6x LEDs: power, wlan2g, wlan5g, lan, wan, wps
- UART: There's no UART header on the board

This commit removes the broken flag for the ipq806x-generic target,
as the first device (NETGEAR R7800) now has full support in Gluon

This commit accounts for the target renaming which was done in upstream
commit 7407e723991 ("ipqx0xx: add Generic subtarget")

This commit accounts for the target renaming which was done in upstream
commit 7407e723991 ("ipqx0xx: add Generic subtarget")

The device is broken until the next release. The LEDs are currently not
working (fixed in current OpenWRT master).

Also give a brief explanation about the BROKEN status being dependent on
the WiFi chip used and not the SoC family in general.

The driver has stablized enough to officially support ramips-mt76x8 devices
again. At least remove BROKEN for VoCore 2 (as it was supported before).

The MT76x8 is currently not stable enough for worry-free use with Gluon.
It suffers from reboots in intervals as little as 12 hours or WiFi
freezes for several hours.

It may be unflagged as soon the situation with mt76 got better.

This commit adds support for the new ipq40xx target.

defaults to 11s, allowing to build devices without IBSS-support

obsoletes GLUON_ATH10K_MESH

There is no wifi, so there is no bad wifi.

[Matthias Schiffer: rebase onto master]

This device has built in wifi we should include it at least for experiments.

Completely untested for now.

Closes #835

Remove obsolete x86-xen_domu definition, it has been merged into
x86-generic.

Needs more testing, high packet loss at the moment.

Fixes #121

Based-on-patch-by: Tobias Hachmer <tobias@hachmer.de>

Config for rootfs and grub is not needed anymore (https://dev.openwrt.org/ticket/18074)

Config file not needed anymore (set implicitly by gluon now)

Avoid empty vars

Original patch by @MPW1412

Includes a profile for the NETGEAR WNDR3700v4 and WNDR4300v1

This still needs some work:

- there's no factory image causing `make images` to fail
- VoCore can not support BSS and IBSS at the same time
- multi-BSS mode (e.g. mesh + BSS) works if the macs only
  differ in the last 3 bits. Gluon expects to choose both MACs freely,
  though, so after flashing the image one should reset the wifi MACs.
  This is further complicated as VoCores have their MACs assigned
  without gaps making collisions likely.
- there are no buttons nor ethernet ports (without the dock, that is),
  so config-mode will not be possible as is