Skip to content
Snippets Groups Projects
  1. Jul 10, 2022
  2. Jul 08, 2022
    • Steffen Förster's avatar
      ath79-generic: add AVM FRITZ!WLAN Repeater 300E support (#2406) · 0cd7af9b
      Steffen Förster authored
      Specifications:
      * SoC: AR7242 (Virian 400MHz)
      * RAM: 64 MB DDR (W9751G6JB-25)
      * Flash: 16MB SPI flash (S25FL129PIF)
      * WiFi: AR9382 (2.4/5GHz) + 2x SE2595L
      * LAN: 1x1000M (PEF7071V)
      
      To install via EVA bootloader, a FTP connection need to be
      established to 192.168.178.1 within the first seconds after power on:
      
        ftp> quote USER adam2
        ftp> quote PASS adam2
        ftp> binary
        ftp> debug
        ftp> passive
        ftp> quote MEDIA FLSH
        ftp> put lede-ar71xx-generic-fritz300e-squashfs-sysupgrade.bin mtd1
      0cd7af9b
  3. Jul 03, 2022
  4. Jun 24, 2022
    • J. Burfeind's avatar
      ath79-generic: (re)add support for NanoStation Loco M5 (XW) (#2562) · 10eca3ba
      J. Burfeind authored
      Gone due to
      commit 45c84a11 ("ar71xx: drop target")
      10eca3ba
    • Manu.WTF's avatar
      ath79-generic: (re)add TL-WR902AC v1 (#2546) · 73471f24
      Manu.WTF authored
      TP-Link TL-WR902AC v1 is a pocket-size, dual-band (AC750), successor of
      TL-MR3020 (both devices use very similar enclosure, in same size). New
      device is based on Qualcomm QCA9531 v2 + QCA9887. FCC ID: TE7WR902AC.
      
      Specification:
      
      - 650/391/216 MHz (CPU/DDR/AHB)
      - 1x 10/100 Mbps Ethernet
      - 1x USB 2.0 (GPIO-controlled power)
      - 64 MB of RAM (DDR2)
      - 8 MB of FLASH
      - 2T2R 2.4 GHz (QCA9531)
      - 1T1R 5 GHz (QCA9887)
      - 5x LED (GPIO-controlled), 2x button, 1x 3-pos switch
      - UART pads on PCB (TP1 -> TX, TP2 -> RX, TP3 -> GND, TP4 -> 3V3, jumper
        resitors are missing on TX/RX lines)
      - 1x micro USB (for power only)
      
      Flash instructions:
      
      Use "factory" image under vendor GUI.
      
      Recovery instructions:
      
      This device contains tftp recovery mode inside U-Boot. You can use it to
      flash OpenWrt (use "factory" image) or vendor firmware.
      
      1. Configure PC with static IP 192.168.0.66/24 and tftp server.
      2. Rename "openwrt-ath79-generic-tplink_tl-wr902ac-v1-squashfs-factory.bin"
         to "wr902acv1_un_tp_recovery.bin" and place it in tftp server dir.
      3. Connect PC with LAN port, press the reset button, power up the router
         and keep button pressed until WPS LED lights up.
      4. Router will download file from server, write it to flash and reboot.
      
      MAC Address summary:
      - wlan1 (2.4GHz Wi-Fi): Label MAC
      - wlan0 (5GHz Wi-Fi): Offset -1 from label
      - eth0 (Wired): Offset +1 from label
      
      Root access over serial line in vendor firmware: root/sohoadmin.
      
      Based on support in ar71xx target by: Piotr Dymacz <pepe2k@gmail.com>
      73471f24
  5. Jun 19, 2022
  6. Jun 17, 2022
  7. Jun 16, 2022
  8. Jun 08, 2022
  9. Jun 05, 2022
    • David Bauer's avatar
      ipq40xx: switch Wave2 firmware to -ct (#2541) · 15ef8858
      David Bauer authored
      
      Use the candelatech firmware for the QCA Wave-2 firmware.
      
      The Qualcomm firmware used for the IPQ401x chip in OpenWrt in 22.03
      is experiencing heavily degraded performance due to excessive
      retransmits when using A-MSDU. Disabling VHT modes or switching to the
      candelatech firmware circumvents this issue.
      
      Apply the same to other Wave-2 platforms in order to keep consistency
      with upstream.
      
      Wave-1 chips do not support mesh modes with the -ct firmware, so keep
      using the QCA firmware in their case.
      
      Signed-off-by: default avatarDavid Bauer <mail@david-bauer.net>
      15ef8858
  10. May 31, 2022
  11. May 30, 2022
  12. May 27, 2022
  13. May 26, 2022
  14. May 17, 2022
  15. May 13, 2022
  16. May 11, 2022
  17. May 04, 2022
  18. May 03, 2022
  19. May 02, 2022
  20. May 01, 2022
  21. Apr 21, 2022
  22. Apr 17, 2022
  23. Apr 07, 2022
  24. Apr 05, 2022
  25. Apr 04, 2022
  26. Apr 03, 2022
  27. Apr 02, 2022
  28. Apr 01, 2022
  29. Mar 31, 2022
  30. Mar 29, 2022
Loading