Skip to content
Snippets Groups Projects
Select Git revision
  • 7e5f0fe1d5d358e9208cb37d7a92110574d1730e
  • v2018.2.x default
  • experimental
  • master
  • v2021.1.2-ffs
  • v2021.1.1-ffs
  • nrb/gluon-master-cpe510
  • v2021.1-ffs
  • v2020.2.3-ffs
  • nrbffs/fastd-remove-delay
  • v2020.2.2-ffs
  • v2020.2.1-ffs
  • v2020.2-ffs
  • v2020.2.x
  • v2020.1.3-ffs
  • v2020.1.1-ffs
  • v2020.1-ffs
  • v2019.1.2-ffs
  • v2019.1.1-ffs
  • nrb/test-radv-filter
  • v2019.1-ffs
  • nrbffs/netgear-ex6120
  • v2021.1.2-ffs0.2
  • v2021.1.2-ffs0.1
  • v2021.1.1-ffs0.4
  • v2021.1.1-ffs0.3
  • v2021.1.1-ffs0.2
  • v2021.1.1-ffs0.1
  • v2021.1-ffs0.1
  • v2020.2.3-ffs0.3
  • v2020.2.3-ffs0.2
  • v2020.2.3-ffs0.1
  • v2020.2.2-ffs0.1
  • v2020.2.1-ffs0.1
  • v2020.2-ffs0.1
  • v2020.2
  • v2020.2.x-ffs0.1
  • v2020.1.3-ffs0.1
  • v2020.1.1-ffs0.1
  • v2020.1-ffs0.1
  • v2019.1.2-ffs0.1
  • v2019.1.1-ffs0.1
42 results

template_lmo.h

Forked from firmware / FFS Gluon
Source project has a limited visibility.
user avatar
ar71xx-generic: Use eth0 as OpenMesh primary mac address
Sven Eckelmann authored and Sven Eckelmann committed 
The OpenMesh devices have a sticker with the eth0 mac address on the
bottom. Also all other mac addresses are calculated based on this address.
Therefore, it is better to use this as primary mac address instead of the
WiFi mac address.

Signed-off-by: default avatarSven Eckelmann <sven.eckelmann@open-mesh.com>
780f7cad
History
user avatar 780f7cad
History

Impressum - Datenschutz